Asian Journal of Engineering and Applied Technology (AJEAT)
Current Status of Prevention of Hot Corrosion of Boiler Steels with Thermal Spray CoatingAuthor : Gurdeep Singh, Indermeet Singh and Khushdeep Goyal
Volume 7 No.2 Special Issue:November 2018 pp 121-126
In the thermal power plant, various conventional steels are used to manufacture boiler components. Due to high operating temperature of these boilers, these conventional steels are unable to resist hot corrosion. In recent years researchers have used various techniques to resist hot corrosion out of these techniques, thermal spray coating process have gained lot of interest due to the ease of coating, low operating cost, and various other advantages. With these coating processes a thin layer of coating material is developed over steel alloys surface which creates hindrance to penetration of corroding element and hereby reduce corrosion. This paper is an attempt to present a comprehension the study related to hot corrosion of thermal spray coating on boiler steels at high temperatures.
Thermal Spray, Microstructure, Corrosion, Porosity, Mechanical Properties
 D. Gond, V. Chawla, D. Puri and S. Prakash, “High Temperature Corrosion Behavior of T-91 and T-22 Bare Steel in 75wt%Na2SO4+25wt%NaCl Molten Salt Environment at 900°C”, Journal of Mineral and Material Characterization and Engineering, Vol. 9, pp. 593-606, 2010.
 S. Srikanth, B. Ravikumar, SK. Das, et al. “Analysis offailure in boiler tubes due to fireside corrosion in a waste heat recovery boiler”, Eng Fail Anal, Vol. 10; pp. 59-66, 2003.
 G.J. Santoro, F.J Kohl and C.A. Stems, et al., “Experimental and deposition rates from salt seeded combustion gases of a mach 0.3 burner rig, NASA Technical Paper; 2225, 1984.
 M.A DeCrescente, N.S Bornstein, “Formation and reactivity thermodynamics of sodium sulfate with gas turbine alloys”, Corrosion, Vol. 24, pp. 127-133, 1968.
 S Kamal, R Jayaganthan, S Prakash, “Evaluation of cyclic hot corrosion behaviour of detonation gun sprayed Cr3C2-25%NiCr coating on Nickel and iron based superallys”, Surf Coat Tech, Vol. 203, pp. 1004-1013, 2009.
 M. Ramesh, S. Parkash, S. Nath, et al., “Solid particle erosion of HVOF sprayed WC-Co/NiCrFeSiB coatings”, Wear, Vol. 269, pp. 197-205, 2010.
 HS. Sidhu, BS. Sidhu, S. Parkash, “Mechanical and microstructure properties of HVOF Sprayed WC-Co and Cr3C2-NiCr coating on boiler tube steels using LPG as the fuel gas”, J. Mater Process Tech”, , Vol. 171, pp. 77-82, 2006.
 MA. Uusitalo, PMJ. Vuoristo, TA. Mantyla, “High temperature corrosion of coating and boiler steel in oxidizing chlorine containing atmosphere”, Mater Sci Eng, Vol. 346, pp. 168-177, 2003.
 R. Sivakumar, SV. Joshi, “Protective Coating by Plasma Spraying: A Review”, T Indian Ceram Soc, Vol. 50, pp. 1-14, 1991.
 K. Szymanski, A. Hernas, G. Moskal, et al., “Thermally sprayed coating resitant to erosion and corrosion of power plant boiler- A Review”, Surf Coat Tech; Article in press, 2014.
 A. Lopez, M. Proy et al., “high temperature corrosion behavior of Ni-50Cr coating deposited by HVOF technique on low alloy ferritic steel”, Mater des, Vol. 59, pp. 94-102, 2014.
 S. Kamal, R. Jayaganthan and S. Parkash, “Hot Corrosion Studies of Detonation-Gun-Sprayed NiCrAlY + 0.4 wt.% CeO2 Coated Superalloys in Molten Salt Environment”, Journal of Materials Engineering and Performance, Vol. 20, pp. 1068-1077, 2010.
 S. Chatha, H. Sidhu and B. Sidhu, “High Temperature Hot Corrosion Behaviour of NiCr and Cr3C2–NiCr Coatings on T91 Boiler Steel in an Aggressive Environment at 750 °C, Surface & Coatings Technology, Vol. 2, pp. 3839–3850, 2012.
 S. Chatha, H. Sidhu, B. Sidhu, “High Temperature Hot Corrosion Behaviour of NiCr and Cr3C2–NiCr Coatings on T91 Boiler Steel in an Aggressive Environment at 750 °C”, Surface & Coatings Technology, Vol. 2, pp 3839-3850, 2012.
 N. Jagadeeswaran, M. Ramesh, K. Bhat, “Hot Corrosion Studies on As-received and HVOF SprayedAl2O3+CoCrAlTaY on Ti-31 Alloy in Salt Environment, International Conference On Design and Manufacturing, Procedia Engineering, Vol. 3, pp-1013-1019, 2013.
 R. Bhatia, H. Singh, B.S Sidhu, “Hot Corrosion Studies of HVOF-Sprayed Coating on T-91 Boiler Tube Steel at Different Operating Temperatures”, Journal of Materials Engineering and Performance, Vol. 23, pp 493-505, 2013.
 G. Singh, T. Singh, “To Study High Temperature Erosion-Corrosion of Detonation Gun Sprayed Al2O3 Coated and Uncoated T-91 Boiler steel in Actual Environment of Boiler”, International Journal of Science and Research (IJSR), Vol. 3, pp261-264, 2014.
 B. Singh, A. Jain, V. Chawla, “Evaluation of Erosion-Corrosion Resistance of Some Detonation Gun Sprayed Coatings on Grade A-1 boiler Steel in a Coal Fired boiler”, International Journal of Engineering, Vol. 2, pp. 13-18, 2015.
 S. Singh, K. Goyal, R. Goyal, “Performance of Ni3Al and TiO2 Coatings on T91 Boiler Tube Steel in Simulated Boiler Environment at 900°C”, Journal of Thin Films, Coating Science Technology and Application, Vol. 3 ,pp-27-34, 2016.
 G. Singh, N. Bala, V. Chawla, “High Temperature Oxidation Behaviour of HVOF Thermally Sprayed NiCrAlY Coating on T-91 Boiler Tube Steel”, 6th International Conference of Materials Processing and Characterization, Proceedings, Vol. 4 , pp. 5259–5265, 2016.
 S. Chatha, H. Sidhu, B. Sidhu, “Performance of 75Cr3C2-25NiCr Coating Produced by HVOF Process in a Coal-Fired Thermal Power Plant”, Advanced Materials Research, ISSN: 1662-8985, Vol. 2, pp. 88-100, 2016.
 V. Sidhu, K. Sidhu, Goyal, R. Goyal, “An Investigation of Corrosion Resistance of HVOF Coated ASME SA213 T91 Boiler Steel in an Actual Boiler Environment”, Anti-Corrosion Methods and Materials, published online, 2017.
 C. Jiang, W. Liu et al., “The Corrosion Behaviours of Plasma-Sprayed Fe Based Amorphous Coatings”, Surface Engineering, published online, 2017.
 SS. Chatta, HS. Sidhu, BS. Sidhu, “Characterization and corrosion – erosion behavior of carbide based thermal spray coating”, Journal of Minerals and Material Characterization and Engineering, Vol. 11, pp. 569-579, 2012.
 P. Niranatlumpong, H.E. Evans, and B. Ponton, “Failure of protected oxide on plasma sprayed on Ni Cr Alloys Overlay Coatings”, Oxidation of metals, Vol. 53, pp. 3-4, 2000.
 B. Singh, and S. Parkash, “Evaluation of the corrosion Behavior of plasma sprayed Ni3Al coating on Steel in oxidation and molten salt environment at 900ºC”, Surface Coating Technology, Vol. 166, pp. 89-100, 2003.
 H. Singh, B. Singh and S. Prakash, “The microstructure and mechanical properties of HVOF sprayed Cr3C2 Coating on the boiler tube tubes” Journal of material processing technology, Vol. 171, pp. 77-82, 2006.
 N. Bala, S. Parkash, and H. Singh, “Accelerated hot corrosion of cold spray Ni-50Cr Coating on Boiler steels”, Materials and design, Vol. 31, pp. 244-253, 2006.
 T. Sidhu, S. Parkash, and R.D. Aggarwal, “Hot corrosion HVOF sprayed Cr3C2 –Ni Cr and Ni -20Cr.on nickel based super alloy in the molten salt environment of Na2So4 60% at 900 deg C”, Surface coating and Technology, Vol. 201, pp 792-800, 2006.
 S. Kamal, S. Parkash, S. Kumar, and R. Jayanathan, “Hot Corrosion Behavior of Detonation Gun sprayed Ni Cr coatings on fe (Iron) based Super alloys in Na2So4 Environment at 900 Degree C”, Journals of alloys and compounds, Vol. 463, pp 358-372, 2008.
 R. Kumar, V. Tewari, and S. Parkash, “Hot Corrosion of Micro structurally different regions of 2.25Cr-1Mo (T-22) Boiler tube Weldment”., Journals of Material Engineering and Performance, Vol. 18, pp 959-965, 2009.
 R. Jayanathan, S. Kamal, and S. Parkash, “Hot Corrosion studies of Detonation gun sprayed Ni Cr Al Alloy + 0.4 wt.% CeO2 coated Super alloys in molten salt Environment”, Journals of Material Engineering and Performance, Vol. 20, pp. 1068-1077, 2011.
 S. Singh, K. Goyal, and R. Goyal, “performance of Cr3C2-25 (Ni-20Cr) and Ni-20Cr coatings on T-22 Boiler steel tube material in Stimulated Boiler Environment”, Journals of Thin Films, Coatings Science Technology and Applications, Vol. 3, pp, 19-26, 2016.
 R. Kumar, V. Tweari, and S. Parkash, “Oxidation Studies on base Metal , Weld Metals and HAZ regions of TIG weldments in 2.25Cr-1Mo (T-22) boiler Tube under cyclic conditions” , Vol. 86, pp. 407-415, 2016.
 S. Singh, K. Goyal, and R. Goyal, “Performance of Ni3Al and TiO2 coatings on T-91 material of Boiler tube steel in Stimulated boiler environment at 900ºC”. , Journals of Thin Films, Coatings Science Technology and Applications, Vol. 3, pp 27-34, 2016.
 A. Mangla, V. Chawla, and G. Singh, “Comparative hot Corrosion behavior of HVOF and Plasma Sprayed Ni-20Cr Coated T-22 Steel in Actual Coal Field Boiler Environment”, Journals of Engineering Science and Researches, ISSN 2348-8034, 2017.